Untitled design (60)
Midnite20Solar20Lightning20Arrestor20Specs.jpg Midnite20Solar20Lightning20Arrestor203.jpg Midnite20Solar20Lightning20Arrestor20Install20-202.jpg

MidNite Solar Lightning Arrestor and Surge Protection Device (SPD)

$107.98

The MidNite Solar Surge Protector Device is designed for both AC and DC systems

Clear

Description

The MidNite Solar Surge Protector Device is designed for both AC and DC systems

Recommended for protecting a inverter, charge controller, and solar system against EMP or Electro Magnetic Pulses from solar flares or other sources.

LED shows if fuse has blown or if SPD is functioning.  Clamping voltage as low as 385 V.

The MidNite Solar Surge Protector (MNSPD) is a Type 2 device. It is designed for both AC and DC systems and provides protection to service panels, load centers or where the SPD is directly connected to the electronic device requiring protection. Maximum protection will only be achieved if the SPD is properly installed. The MidNite Solar SPD is offered in three different voltages to maximize the required protection level. Protection is achieved by reducing the clamping voltage to a safe voltage that your system can sustain without damaging any electronics in the system. The MidNite Solar SPD voltage rating should be chosen according to the nominal voltage of the system. Response time is 8/20µs to clamp 128,000 amps. There are two LED’s in each unit that will indicate when the unit is functioning correctly and there is voltage to it.

Install the 150V DC version for surge protection on wires coming from a 12, 24, or 48v PV array, DC wind generator or DC hydroelectric turbine, the 300VDC unit for DC sources up to 300v, and the 600VDC unit for high-voltage grid-tie PV arrays. Lightning protection can be installed in a combiner box, DC load center or grid-tie inverter. They can be used on your AC load center to protect your equipment from surges from the utility lines and on AC wiring running outside of the building, to generators, pumps or outbuildings. Mounts easily in a 1/2″ knockout. Material and workmanship warranty for 5 years.

Additional information

Weight 1 lbs
Volts

0-115 Volts DC, 0-300 Volts DC, 0-600 Volts DC, 0-300 Volts AC